Auto-synced from the crew's Google Sheet — last checked Oct 15, 2026. Edit the sheet and this page updates within a day.
Electrical
| Item | Part # / ref | Notes |
|---|---|---|
| Full set of electrical connections - all sizes - both heat shrinkable and regular | — | located in packout boxes |
| Heat shrink tubing - various sizes | — | — |
| Solder | — | — |
| Heat shrink solder fittings | — | — |
| Deutsch Pin connector set 2/4/6/8 pin with crimpers | — | I had a couple of Deutsch Pin connectors on Yanmar break due to maintenance people in engine room |
| Wire - 18 gauge, 16/14/12/10 - various colors - 20 meter lengths | — | — |
| Breakers - AC - Type B curve 6/10/16/20 amp and Type C Curve 10/16/40 amp - 2 pole | — | I have had two breakers in AC distribution panel fail |
| Fuses - all of the variety on board - I will make a list. | — | — |
| Fuse - special - for MG Battery terminals | — | — |
| Fuse - special - for MG Master | MG part MGFUSE1580300, corresponding to Littelfuse CF8 155.0892.6301. | — |
| Fuse - special - MG Master - Pre-charge circuit fuse | Bel Fuse 5HT 10-R | 10 A / 250 V 5 × 20 mm, time-lag, surge-withstand, high-breaking-capacity ceramic |
| Fuse - special - Main/control electronics fuse | Multicomp Pro MC000850 | 6.3 A / 250 V 5 × 20 mm, fast-blow, ceramic |
| Cable - ethernet cable, 240V AC cable - 2 meters each | — | — |
| Shore power AC connections fittings - 63A to 32A adapter, 16A to 32A , weird 4 pin 32 A to 3 pin 32 A for Montenegro , and spare ends for each | — | — |
| Tape - all types - vulcanizing tape, electrical tape etc | — | — |
| Nema 2000 - cable, T's - a few spare…. | https://www.maretron.com/products/nmea-2000-cables-and-connectors/ | https://www.maretron.com/products/pdf/Micro%20Term%20Feed%20thru%20Multi%20Datasheet.pdf — the Maretron connectors and cables are far superior vs. other brands and what is installed by Kraken. These Maretron multi port connectors are very well built. |
Rigging
in packout boxes in engine room
| Item | Part # / ref | Notes |
|---|---|---|
| Spare halyards, and spare lines for all running rigging | — | — |
| Spare shackles - various sizes | — | — |
| Cotter pins - various sizes | — | Especially rigging cotter pins that you will change when you adjust rigging |
| for Code K - Karver furling - spare pin suggested | lock Pin Karver KF4.5 | — |
Plumbing
in packout boxes in engine room
| Item | Part # / ref | Notes |
|---|---|---|
| Washers and O rings - various sizes | — | — |
| Elbows, unions, nipples, reducers, and other fittings, various sizes | — | — |
| Full set of hose clamps - various sizes | — | — |
| Hoses - 2 meters of every hose type on board | — | — |
| Pumps - one spare pump for every pump on board | — | — |
| Filter baskets - spare for main sea chest and Genset and yanmar filter baskets | FTR17 SS Basket for Vetus FTR1900 | my main sea chest filter basket - difficult to source from Vetus and is corroded |
General / Other
in packout box AFT Laz
| Item | Part # / ref | Notes |
|---|---|---|
| SS screws, bolts, nuts - various sizes and all types | — | — |
| Anodes - full set 3X | — | — |
| 80 meters + 8mm or 10mm dyneema - as you never know when you will need | — | — |
| Sealant - all types with a squeezer | — | — |
| Bow Truster shear pin - the sacrificial sheer pin | — | K005's failed numerous times - kraken recut the tunnel and put a larger bow thruster in - have not had to replace since larger thruster |
| Bow thruster - spare props - 2 of them | — | for when you suck mooring line into your bowthruster |
| Dinghy Motor - spare prop | — | for when you run aground |
| boat hook - spare for when yours goes overboard | — | — |
Engine/Genset
in packout box AFT Laz
| Item | Part # / ref | Notes |
|---|---|---|
| Yanmar 4jh80 | — | — |
| Cummins Onan | 7MDKDL-8211A S/N J210991359 | https://www.cummins.com/en-na/generators/products/onan-marine-qd-79-kw-marine-generator |
| Fuel Water Separator - Vetus | 712UTE | Vetus 712VTE - Water Separator and Fuel Filter Single 10 Micron for Diesel Fuel Systems |
| Full set of all filters - 3X | — | for genset and yanmar |
| Full set of all impellers - 3X | — | for genset and yanmar |
| Engine oil | 15W40 | — |
| Gear oil | SAE30 | — |
| Belts - 2X for all belts | — | alternator, 2nd alternator if fitted, hybrid drive |
| Yanmar gearbox - (haha - just kidding) | — | — |
| Combi - CURTIS 1314 programming interface for windows | — | to adjust the combi motor settings such as power usage for regeneration |
Autopilot - JEFA spares (thanks Skymark)
Locted under aft cabin bed
| Item | Part # / ref | Notes |
|---|---|---|
| UJ10 universal joint | UJ10 | — |
| DL025035-25 Drag Link | DL025035-25 | — |
| Spare parts for the drive unit: DU-TS6-24 MOR,- + DU-COSET-24 | DU-TS6-MOR | DU-COSET-24 |
| DLB16 - just drag link bushing (skymark has replaced) | DLB16 | — |
WaterMaker -AquaPrime 150L/hr
Locted under aft cabin bed
| Item | Part # / ref | Notes |
|---|---|---|
| MEMBRANE FILMTEC 40''X40'' | — | 1 730 730,00 Euro |
| SUTEM HIGH PRESSURE PUMP REPAIR KIT | — | 1 85 85,00 Euro |
| SP1411 | — | — |
| TELLARINI LOW P. PUMP REPAIR KIT 1 35 35,00 Euro | — | — |
| JIM 6 | — | — |
| ELECTRIC MOTOR REPAIR KIT 1 30 30,00 Euro | — | — |
| 2,2 KW 220 V | — | — |
| PNEUMATIC HOSE KIT | — | 1 60 60,00 Euro |
| HIGH PRESSURE HOSE & FITTINGS | — | 1 220 220,00 Euro |
| FILTER 10'' 5 MIC | — | 1 6 6,00 Euro |
| CARBON FILTER 10'' | — | 1 7 7,00 Euro |
| FILTER HOUSING 10'' | — | 1 30 30,00 Euro |
| ALKALINE CLEANING DETERGENT | — | 1 20 20,00 Euro |
| ACIDIC CLEANING DETERGENT | — | 1 20 20,00 Euro |
| MEMBRANE WINTERISING | — | 1 35 35,00 Euro |
| ORING KIT | — | 1 30 30,00 Euro |
| HANNA PPM TESTER | — | 1 300 300,00 Euro |